Matala lavettipuoliperävaunu

FAYMONVILLE MAX Trailer MAX510 Tiefbett 2x10 t

You can find our complete stock of immediately and soon-to-be available vehicles on our website.

Excerpt from equipment specification. Complete specification available on request.

Load area:
- Low-bed design with central beam, extendable version, approx. 6,750 mm in length
- 5 pairs of fold-out external lashing rings (LC 5,000 daN)
- 1 pair of fold-out external lashing rings (LC 10,000 daN)
- 1 pair of flat-mounted lashing rings at the rear of the loading platform (LC 10,000 daN)

Gooseneck:
- Hydraulic lifting/lowering gooseneck, detachable

Rear chassis:
- Short rear chassis with closed outer frame and checker plate covering
- Chassis with excavator trough, closed in the rear half for housing the air tanks
- 2 pairs of fold-out external lashing rings (LC 5,000 daN)
- 1 pair of fold-out external lashing rings (LC 10,000 daN)
- 1 pair of flat-mounted lashing rings at the rear of the chassis (LC 10,000 daN)

Axles:
- BPW axles, hydro-mechanically forced steering
- Air suspension with raise/lower control valve

Tyres:
- Tyres 245/70 R 17.5, 3PMSF
- TPMS: Tyre Pressure Monitoring System according to ECE R 141

Iiodpfx Aoxf Silsbwok
Brake system:
- Wabco braking system in accordance with EU regulations with EBS-E (2S2M)

Paintwork:
- High-quality single-tone 2-component (2K) top coat in RAL 3000 Flame Red

Including the following additional equipment:
- 2 kingpins
- Galvanised steel front wall, approx. 400 mm high
- Remote steering from front and rear, operated by cable remote control with push buttons, including single tracking control for the axles (no installation in the tractor unit)
- Electro-hydraulic unit
- Axle load gauge including load diagram
- On the gooseneck, removable aluminium side walls and rear wall, approx. 2,440 x 400 mm (L x H). Rear galvanised stake pockets are removable. (Body length approx. 2,560 mm)
- Separate air connection with air gun on the gooseneck
- 2 work lights with switch on the trailer, mounted on the left and right of the gooseneck platform
- 1 INOX toolbox, approx. 1,350 x 400 x 400 mm, on the gooseneck
- 6 pairs of stake pockets for insertable posts approx. 100 x 50 mm in the outer frame of the load area, 2 pairs in the chassis outer frame
- Galvanised, extendable width extensions approx. 230 mm per side
- Hydraulic connections from gooseneck to low bed with multi-coupling (instead of screw couplings). No seal guarantee included.
- Central lubrication system with 2 BEKAMAX (Pico) pumps, standard NLGI-2 grease, with removable protection around the pump
- 2 pairs of WADER container locks on the loading area, for 1x20' container
- 1 removable galvanised intermediate table with 1 pair of WADER container locks
- 1 pair of steel ramps for bridging the low bed’s hook mountings
- Anti-slip sand-coated layer painted on the load area
- HRM Metallisation (High Resistance Metallisation)

Mainos käännettiin automaattisesti ja käännösvirheet ovat mahdollisia.