Työalustallinen perävaunu

MÜLLER-MITTELTAL 3-Achs Plateau, luftgefedert, hydr. Rampen

* PT 30 Profile:

----Brakes:
* EBS (electronic braking system)
* Emergency release device for spring brake cylinders
* Drum brakes

----Axle:
* 3 x 11-ton Gigant axles

----Suspension:
* Air suspension with lifting and lowering system, and quick-release valve

----Drawbar:
* 1,200 mm long drawbar with 40 mm drawbar eye and height adjustment via tension spring & locking mechanism

----Electrical system / Lighting:
* Smart board mounted on the trailer as an information tool (for axle load display – separate display for front and rear)
* Tire pressure monitoring with display option in the truck via EBS signal without truck-side installation
* 15-pin power connector
* LED lighting 12 / 24 V
* LED rotating beacon (removable) at the rear

----General components:
* Lateral impact protection
* Swivel supports at the rear of the chassis frame
* Mechanically adjustable warning sign packages at the front and rear
* Front plastic quarter fenders with splash protection
* Rear straight, galvanized steel mudguards with splash protection
* Toolbox made of galvanized sheet steel, approx. 650 x 300 x 600 mm, black powder-coated, on the right side
* Box in the turntable for accessories with hinged lid, 2 continuous locking mechanisms, permanently installed (directly behind the turntable platform)
* 2 galvanized steps on the turntable, left + right

----Low-loader platform:
* Robot-welded, anti-slip surface on the steel plate of the turntable platform (protruding weld beads)

----Load securing (load securing package consisting of):
Nwedpfxetplwij Aicen
* 2 lashing points (13.4 tons) at the front, left & right on the front wall support
* 1 pair of UVV lashing rings (13.4 tons) at the front & rear, as well as 3 pairs of UVV lashing rings (10 tons) on each side, swiveling and lowering, loadable in all directions and recessed in the outer frame
* 3 lashing pockets on each side with simultaneous 2-ton lashing capacity
* Profifix lashing rail in the longitudinal axis, in the center, in the level area for lashing up to LC 3000 daN

----Widening:
* 6 pairs of mechanical folding outriggers for a total width of 3 m (however, not in the rear slope)
* Widening planks stored in the center of the loading area

----Ramps:
* Hydr. one-piece loading ramps approx. 3,000 x 720 mm
* Mechanically adjustable on the side
* Control block, 4-way, for later retrofitting of hydraulic ramp adjustment

----Excavator arm rest:
* Excavator arm rest extending across the rear axle to the end crossmember (total length approx. 2,100 mm)
* 2 pairs of lashing points LC 6400 daN in the excavator arm rest on the side in the longitudinal frame

----Loading height:
* Laden approx. 910 mm +/- 20 mm, air suspension

----Paint:
* Chassis, turntable, folding outriggers, support legs, and loading ramps hot-dip galvanized
* Axles, slewing ring, air tank, drawbar eye painted in a black tone

----Information:
* New vehicle with manufacturer's warranty
* Errors and prior sale reserved

----Delivery time:
* Available for immediate delivery from Egestorf

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.