Kippipuoliperävaunu

Fliegl DHKA 390 25 m³

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer requirements.

More information:
Chassis
Fine-grained steel welded construction, lightweight design, kingpin plate with 2 interchangeable kingpins
Curved front end, patented
Telescopic support in the center, cannot be uncoupled with load, in the uncoupled state, the vehicle must stand at an angle towards the rear.
2 chock blocks + holder
Underrun protection, foldable
Semi-shell fenders
Integrated fender holder, surface repels stones
with anti-splash flaps on the last axle
1 tarpaulin rod + holder
2 towing hooks at the rear
Axles + suspension
SAF disc brake axles with 430 mm disc diameter
Axle/suspension laser-aligned to reduce tire wear and fuel consumption
Axles in off-road design
Air suspension
1st axle automatic lift axle, incl. forced lowering and start-up assist, operated 3x by braking (start-up assist functional up to an axle load exceedance of 30% and a speed of max. 25 km/h)
Hot-dip galvanized lift axle mechanism
Braking system
2-line pneumatic braking system, color-coded lines for easy servicing
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front, without connection line
EBS, electronic braking system with EBS socket at the front, without connection cable
Attention: Trailer may only be pulled by towing vehicles that guarantee the effectiveness of ABS!
with lifting and lowering valve
Vehicle driving stability system
Automatic tilting lowering with shut-off valve
Wheels & tires
385/65R22.5, manufacturer's choice
Steel rims, factory silver
Electrical system
24 Volt multi-chamber lights, yellow LED lighting on the side
2 white position lights at the front
2 white/red marker lights at the rear
2 x 7-pole non-interchangeable sockets at the front, without connection cable
Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard-chromed, with HDK screw fitting, fixed part NW 48 mm.
Actuation via truck auxiliary drive
Tipping body
Lhodpfx Alei Ri R Isgoh
Aluminum box body, sloping front wall 5 mm thick, 30 mm hollow chamber profiles, cleanly welded, with top rail profile that prevents bulk material from spilling. Inside with ladder on the front wall.
Shovel and broom holder on the outside of the front wall.
Greenline - conical and aerodynamic tipping body shape
Membrane - rear wall
Rear wall as a hinged flap with double hinge, externally mounted with a double hook lock.
Rear wall with rubber seal. Note! Heat resistant up to max. 170°C!
Floor continuously 6 mm thick
Standing platform with ladder, connecting plate for air/electricity and brake with large clearance for best possible operation.
Roller cover on one side for storage on the right, with central locking on the left.
Operating instructions
For the transport of salt, lime, etc., we recommend a tipping cylinder with a hard-chromed piston rod, so that it is not attacked by the material and does not rust.
The stated total weight is technically possible, but depending on the load, the total weight may not be reached while observing the permissible axle/support and kingpin loads. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of approval/signage
Germany
Type approval according to EC 2007/46
24/7 service hotline
prepared for license plate holder, single row
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.