Matala kuormaaja

Fliegl DTS S 300 Parab/Hydr.

Further information
Low-bed trailer chassis
Steel welded construction
Turntable with robust ball bearing
Foldable rear support
2 wheel chocks with holder
Aluminum side impact protection
Splash flaps at the rear, covering the entire width
Half-shell fenders on the 1st axle with anti-spray splash flaps, anti-spray splash flaps behind the 2nd and 3rd axles
1 plastic toolbox with insert, w=620/h=360/d=440 mm, lockable with a padlock
Extendable widening sections to 3,000 mm
Storage compartment for wooden planks in the center of the loading area
Wooden planks, 70 mm for widening to 3,000 mm
Lashing points for low-bed trailer (40 lashing possibilities)
1 pair of lashing points in the longitudinal beam at the front, recessed in the cranked section, each 10 tons
4 pairs of lashing holes in the outer frame, each 5 tons (for attaching lashing straps)
7 pairs of lashing eyes recessed at the top and side in the outer frame, each 10 tons
1 x at the front in the cranked section
6 x in the low-bed
First lashing point 250 mm from the front and last max. 250 mm from the rear, distance between lashing points not greater than 1100 mm
5 pairs of pocket for securing beams recessed in the outer frame, inside 70 x 40 mm (convertible to 5 ton ring lashing points)
2 pairs of folding lashing points in addition, each 10 tons
1 x on the cranked section (protrudes)
1 x behind the last axle, recessed in the floor
Coupling device for trailer turntable
Drawbar with tested 40 mm towing eye
Axles + Suspension
Drum brake axles
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load compensation (lever compensation)
Wheels and Tires
235 / 75 R 17.5
at the manufacturer's choice
Steel rims in twin arrangement, factory silver
Braking System
2-line pneumatic braking system
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front, with connecting lines to the towing vehicle
ABS and ALB, with ABS plug at the front, with connecting cable
Manufacturer: Wabco, Knorr or Haldex
Electrical System
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red outline lights at the rear
Pjdpfei Ri Dlox Al Togn
2 x 7-pole non-interchangeable plugs at the front, with connecting cable
1 LED rotating beacon with holder, switched via parking lights (light can be removed)
2 pairs of warning signs double LED illuminated and extendable to 3,000mm
Floor
Cranked section at the front with steel/diamond plate covering
Storage box recessed in the sloping transition to the cranked section
thereafter with 70 mm softwood floor, in the wheel arch area steel/diamond plate covering
Rear sloping section with 70 mm softwood floor
Low-bed surface including rear sloping section 6,500 mm
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally movable
covered with wood
Hydraulically operated via tractor unit auxiliary drive with throttle, actuation on the left-hand side (FR)
Hydraulic connection with SVK plug NW 10/3, incl. connecting hose
Country of Registration / Signs
Country of Registration: Germany
24/7 service hotline
prepared for license plate holder, two-line
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Warning sign according to ECE - 70
Painting
Frame hot-dip galvanized including passivation
15 years warranty against rusting
Drawbar galvanized or black, at the manufacturer's choice
Ramps hot-dip galvanized
Attention! These are archive images!

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.