Kippipuoliperävaunu

Fliegl DHKS 390 - 50 m³ LightMaster Agrar

Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs.

More information
Chassis, Saddle, Tipper
Fine-grained steel welded construction, in basic lightweight design, saddle plate with interchangeable 2 kingpin
Curved front end, patented
24 ton, 2-speed support winch, single-sided operation, with straight lower part, without thrust compensation
Wheel chocks with holder
Underrun protection, foldable
Half-shell fenders
Integrated fender holder, surface designed to repel stones
Tarp rod with holder
Towing hook at the rear
Axles + Suspension
BPW disc brake axles with 430 mm disc diameter
Axle/suspension laser-aligned to reduce tire wear and fuel consumption
Air suspension
1st axle, automatic lift axle, including forced lowering and start-up assistance
Hot-dip galvanized lift axle mechanism, 10-year warranty against rust-through
Braking system
2-line compressed air braking system, color-coded lines for easy servicing
Spring-loaded parking brake
2 fail-safe coupling heads at the front, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
Note: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
With raising and lowering valve
Vehicle - driving stability system
Wheels and tires
385/65 R22.5
Steel rims, factory silver
"TPMS" tire pressure monitoring system according to ECE R 141, display via display in the towing vehicle, via EBS, without truck installation (this must be available in the truck. Only on standard tires).
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
Yellow LED lighting on the sides, linked to the turn signal ("flashing side lights")
2 x 7-pole fail-safe sockets at the front, without connecting cable
Hydraulics
Low-pressure cylinder, max. 170 bar, smallest stage hard-chromed, with HDK screw-on fitting, fixed part, NW 48 mm (without hose connection)
Operation via truck auxiliary drive
Body
Steel side body made of highly wear-resistant HB 400 steel, sloping front wall with externally mounted hydraulic cylinder mount. Shovel and broom holder on the outside of the front wall. Internal access ladder on the front wall.
Side walls continuously 3 mm thick, floor continuously 3 mm thick
Membrane - rear wall
Internal width at the bottom approx. 1440 mm
Aluminum rear wall, pendulum-mounted with "double-hinge hinge" and with 2-wing door, split 1/2 to 1/2, at the top with pivoting boom, each with a grain slide per door.
Standing platform with access ladder, connection plate for air/electricity and brake with large space for optimal operation.
Roller cover on one side for placement on the right side, with central locking on the left side
Country of approval/signs
Germany
Type approval according to EC 2007/46
Body strength according to EN 12642
24/7 service hotline
Gbodpfxoi Rizfo Afpjw
Prepared for license plate holder, single-line
Warning sign according to ECE - 70
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Paint
Frame: DB 7350 Novagrau
"10-year warranty against rust-through"
Body: RAL, single color, according to customer's choice
Roller cover: RAL 7035 light gray

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.