Matala lavetti perävaunu

MÜLLER-MITTELTAL 11,9 to. Plateau, Luft, 3 m. Cont.- Verriegelung

* ETÜ-TA-ER 14.4 Platform:

----Brakes:

* EBS (electronic braking system)
* Emergency release system for spring brake cylinders
* Drum brakes

----Axles:

* 2 x 5.5 ton BPW axles

----Suspension:

* Air suspension with lifting and lowering system

----Drawbar / Flange drawbar:

* Height-adjustable drawbar by 300 mm
* Drawbar shortened by approx. 200 mm to approx. 1,800 mm (resulting in a B-dimension of approx. 8,080 mm)
* 40 mm flange drawbar

----
Electrical system / Lighting:

* 15-pin power connector
* LED lighting system 12 / 24 V
* 2 LED reversing lights additional at the rear (switched via reverse gear)
* 1 LED rotating beacon (removable incl. bracket) at the rear
* TPMS (Tire Pressure Monitoring System)

----General components:

* Mechanically adjustable 3 m warning sign package at the front and rear
* Support winch at the front
* Outboard folding supports at the rear
* Plastic toolboxes approx. 750 x 350 x 300 mm each on the left & right sides
* Side impact protection
* Underrun protection
* Plastic quarter fenders

----Loading area:

* 400 mm high bolted front wall
Guedpey U A Elofx Amnjh
* 50 mm hardwood floor,
* 2 pairs of container locking mechanisms (extendable to 3 m container outer width) and lockable, locking dimension when retracted according to ISO - DIN 15190 = 2,259 mm. Container locking mechanisms extended = 2,819 mm (this dimension is not according to DIN) with an absolute outer width of 3,000 mm

----Load securing:

* Perforated outer frame approx. 45 degrees angled with 2 ton lashing force every 480 mm
* Installation of 3 ton lashing eyelets every 600 mm possible - 5 x 3 ton UVV lashing eyelets installed on each side -
* In the corners at the front and rear, each 1 x 6.3 ton lashing point (at the front directly behind the container locking mechanisms in the wooden floor and at the rear in the end beam)
* Various drillings in the front and end beam for 1.2 ton lashing

----Ramps:

* 1 pair of aluminum insert ramps approx. 3,310 x 410 mm (load capacity 8 tons / pair) suitable for rubber-tired and tracked vehicles
* Storage compartment at the rear, recessed under the loading area in the chassis

----Painting:

* ---Chassis, drawbar, front wall, underrun protection and rear supports hot-dip galvanized---
* Axles, air tank, support winch at the front and flange drawbar painted in a black tone
----Information:

* New vehicle with manufacturer's warranty
* Errors and prior sale are subject to change
* Sample images

----Delivery time:

* Available from approx. week 50/2026

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.