Kolmisuuntainen kippiperävaunu

FLIEGL TSK 118 Tandem Dreiseitenkipper 5,0m Kipp Anhäng

Further information
Iaedpfx Afsy Dzlistjr

plus pre-transport / provision ex warehouse location 26639 Wiesmoor €1,280.00 / net

Chassis Central Axle Tipping Trailer
Steel welded structure, continuous tipping shaft at the rear with 80 mm ball bearing
Support leg with gear at the front
Foldable rear support
2 wheel chocks with holders
Steel underride guard
Full-width rear mudflaps (not in combination with forklift mounting)
Quarter-section mudguards
1 plastic toolbox, width=600 / height=425 / depth=460 mm, lockable (lock not included)
Note! The sideboard touches the storage box when folded down.
Lockable compartment for loading ramps under the cargo bed
Drawbar system for central axle trailer
Drawbar with certified 40 mm towing eye
Drawbar height adjustable by spindle, max. adjustment range 300 mm
Axles & Suspension
GFA or BPW axles at manufacturer’s choice, with tapered roller bearings and S-cam brakes
“Axle/chassis laser alignment” for reduced tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load equalization (rocker compensation)
Wheels and Tires
235 / 75 R 17.5"
as per manufacturer’s choice
Steel rims in factory silver
Braking System
2-line compressed air braking system
Color-coded lines for easy servicing
Hand spindle parking brake
24 Volt ABS and ALB, ABS connector at the front, with connection cable
Note: The trailer may only be towed by vehicles that ensure ABS functionality!
2 mistake-proof coupling heads at the front, with connection lines to the truck
Electrics
12 to 24 Volts, multi-chamber LED lights, side yellow LED marker lights, license plate lighting in LED
(Note! Certain towing vehicles may display diagnostic errors even if functionality is correct)
2 white position lights at the front
2 white/red lane marking lights at the rear
2 x 7-pin mistake-proof plugs at the front, with connection cable
1 additional LED work lamp at rear, activated by reverse light
Hydraulics
Three-way tipping system, hydraulic multi-piston press with lift limit and safety cable
Low-pressure cylinder up to max. 170 bar, without restrictor. If required, this must be retrofitted to the truck (trucks with max. hydraulic pumping capacity of 55 l/min)
Hydraulic connection with SVK plug NW 10/3, including connecting hose
Operated hydraulically via truck PTO
Tipper Platform
Robust tipper platform with 4 mm steel floor, steel sides, continuous and foldable and swinging sideboards with central locking at the bottom. Removable corner posts at the rear. Drop-down and swinging tailgate, with central locking at the bottom.
Platform length approx. 5,000 mm, sidewalls with 6 hinges at the bottom.
Sideboard retracting springs (not available with foldable front wall)
Platform width 2,420 mm
3 pairs of lashing eyes on floor, each rated for 5 t
Operating Instructions
The specified gross weight is technically possible. Depending on cargo, the gross weight may not be achievable while adhering to permitted axle, support, and kingpin loads. (Poor driving and trailing behavior can result from improper load distribution)
Country of Registration / Plates
Registered in: Germany
With Dekra inspection and certificate (according to §13 EG-FGV)
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on sides and red at the rear
Paintwork
Frame hot-dip galvanized incl. passivation
"15 years warranty against corrosion through rust"
Sideboard/Platform in RAL

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.