Matala lavetti perävaunu

MÜLLER-MITTELTAL 14,4 to. Tand.- Tiefl., breite Rapme, Gummi

* ETÜ - TA -R 14.4

----Brake:
* EBS braking system
* Emergency release device for spring-loaded cylinders
Ijdpfx Abex Ipbaswjik
* Drum brakes

----Axle:

* 2 x 7 t Gigant axles

----Suspension:

* Parabolic springs with compensation unit

----Drawbar / Flange-eye:

* Drawbar adjustable in height by 300 mm (drawbar extension by 250 mm up to 2,250 mm)
* 40 mm flange towing eye

----Electrics / Lighting:

* Tire pressure monitoring with display option in the truck via EBS signal (no installation required on the truck side)
* 15-pin electrical connector
* LED tail lights 12 / 24 V
* LED rotating beacon (removable) at the rear

----General attachments:

* Support winch at the front
* Externally mounted galvanized foldable supports at the rear
* Plastic toolbox approximately 858 x 500 x 500 mm mounted front right outside on the bulkhead
* Side underrun protection
* Plastic quarter mudguards

----Low-loader platform:

* Provision in front of the bulkhead for retrofitting container locks
* Bolted smooth sheet steel bulkhead
* Side panels made of trapezoidal-profiled sheet steel, foldable with drop-side spring assist
* Rear wall made of steel, slidable between the ramps (mounting bracket for stowing in front of the bulkhead when not in use)
* Bolted rear stanchions
* Rear approach angle approx. 860 mm

----Flooring:

* 50 mm softwood floor
* 12 mm thick and 270 mm wide rubber covering strip on the inside of the drive-up ramps
* On the approach slope as well as on the outside of the low-loader platform (from bulkhead to rear end beam) 12 mm thick and 210 mm wide rubber covering strips

----Load securing:

* Perforated outer frame, approx. 45 degrees bent, with 2 t lashing capacity every 480 mm
* Installation of 3 t drop lashing brackets possible every 600 mm
* In the corners front and rear, each with 1 x 6.3 t lashing ring
* Various holes in the front and rear end beams for 1.2 t lashing options

----Ramps:

* One-piece mechanical mesh ramps with spring mechanism for one-man operation approx. 2,750 x 870 mm (collapsible down to 20 mm)

----Paintwork:

* Chassis, drawbar, bulkhead, tailgate and ramps hot-dip galvanized
* Axles, springs, air tanks and flange towing eye painted in a shade of black
* Side panels painted in RAL 9010 pure white

----Info:

* -- Reinforced and certified body according to EN 12642 XL including load securing certificate --
* Errors and prior sale excepted
* New vehicle with manufacturer's warranty
* Sample photos (pictures of the vehicle may vary due to special equipment)

----Delivery time:
Vehicle available from week 10/2026

Mainos käännettiin automaattisesti ja käännösvirheet ovat mahdollisia.