Työalustallinen perävaunu

MÜLLER-MITTELTAL T4 Radmulden / luftgefedert

* T4 RM 40.0:
* Wabco EBS-E (electronic braking system)
* Emergency release device for spring brake cylinders
* Tire pressure monitoring with display capability in the truck via EBS signal (no truck-side installation required)
* Drum brakes
* 4 x 11 ton Gigant axles
* Air suspension with manual lowering at the rear
* Warning sign packages front & rear
* SmartBord infotool mounted with pressure sensors for total axle load display per axle group
* Side and rear reflective contour tape
* Removable LED beacon at the rear
* 15-pin power connector
* LED tail lights
* Straight drawbar with 50 mm towing eye and stepless height adjustment
* Closed single plastic mudguards at the front
* Straight rear steel mud flaps each with spray suppression
* Side underrun protection
* Front extension in front of turntable platform approx. 520 mm with 45° corners and 3 storage compartments incl. lockable folding lids (open to the rear)
* Chassis made of high-strength fine-grain steel
* Floor above turntable platform made of 50 mm softwood and 60 mm softwood on low-bed platform
* Outer planks of the ramps made of 50 mm hardwood
* Load securing package consisting of: 2 lashing eyes 6.4 t front left and right on the main frame of the turntable platform; one pair each (front & rear) of 13.4 t lashing rings on the outer frame; one pair each side of 10 t swivel and lowerable lashing rings, loadable in all directions and integrated in the outer frame; bolted 5 t lashing rings on the outer frames of the wheel wells (2 at the front wheel well, 1 at the rear); 2 pairs of 6.4 t lashing rings at the sides of the excavator boom cradle
Gsdpfx Ajxmpydjfkobk
* 11 pairs of folding outriggers for a total width of 3 meters (not on rear slope)
* Storage compartment (L = 2,470 x W = 570 x H = 250 mm) for widening planks made of sheet steel, mounted transverse to the load area in front of the 1st rear axle
* Excavator boom cradle above the rear axle to end of incline approx. 2,300 x 740 x 190 mm
* 2 wheel wells per side, approx. 640 mm wide – front 340 mm deep, rear 220 mm deep – with sliding cover (storage for covers at the front on the turntable platform) for transporting wheel loaders with 3,100 - 3,640 mm wheelbase
* Mechanical drop-down supports at the rear
* Hydraulic folding ramps with hydraulically deployable tip section approx. 4,650 x 720 mm
* Hydraulic lateral ramp shift
* Loading area above fifth wheel: approx. 2,990 x 2,520 mm
* Rear loading area: approx. 6,780 x 2,520 mm, loaded height approx. 890 mm +/- 20 mm (incl. 860 mm approach slope)
* Chassis, turntable, folding outriggers, rear supports, and ramps hot-dip galvanized
* Axles, air tanks, and drawbar painted black
* Tires: 235/75R17.5
* Vehicle is hot-dip galvanized
* New vehicle with manufacturer warranty
* Subject to change and prior sale
* Immediately available ex Egestorf

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.