Avolava kuorma-auto

MERCEDES-BENZ Arbeitsbühnen Maschinentransporter Rampen

Brand new Mercedes Benz Actros 2540L 6x2 for construction equipment and aerial work platform transport.

Truck equipment:
Nodpfow E Abnsx Ah Ijwc
- Long-distance driver cab
- Auxiliary heating
- Safety package
- Driver comfort package
- Trailer package
- Steerable trailing axle
- LED rear lights
- Euro 6e
- Automatic transmission
- Sun visor
- Beacon lights
- Multifunction steering wheel
- 1 sleeping bunk
- Refrigerator
- Navigation
- 26,000 kg GVW
- Automatic climate control
- White - for long-distance transport - etc.

Body:
- Body manufactured from laser-cut and bent special profiles in low-bed design
- Body length approx. 8,800 mm minus toolbox approx. 490 mm
- Frame height unladen approx. 1,050 mm
- Frame width approx. 2,550 mm
- 2 track ramps, each consisting of 1 fixed section and 1 extendable section, lateral sliding adjustment, grated surface, mechanical ramp locking with holders on outer frame for non-use (optionally with strap securing)
- Ramp operation via electro-hydraulic unit, incl. emergency control at manifold block and hand pump for total system failure
- Hydraulic rear supports
- All hydraulic functions controlled via radio remote control
- Grated floor with increased load capacity
- Rear end with bevel – front bulkhead approx. 2,000 mm high with inward-bent profiles
- Stainless steel toolbox inside in front of bulkhead
- 2 stainless steel side toolboxes on the frame for lashing equipment (1 left, 1 right)
- 1 stainless steel toolbox at rear right (for hydraulic unit and control block)
- Work lights: 1 pair on rear cab wall, 2 pairs on frame sides, 2 pairs at rear
- 2 sets of steps for access to the cargo area

Load securing:
- Longitudinal members incl. Multi-X contour with 2.5 t lashing points
- 6 pairs of 6-ton lashing points integrated into longitudinal members
- Outer frame perforated with 2.5 t lashing points
- 6 pairs of 6-ton lashing points integrated into the outer frame
- 4 x 6-ton lashing points at the rear
- 4 x 6-ton lashing points below, in front of the front bulkhead toolbox

Paintwork:
- Body powder coated in RAL 9005 black (KTL process)
- Bulkhead painted in RAL 9005 black
- Ramps and gratings hot-dip galvanized

Markings:
- Reflective tape on sides and rear to EU regulations.

Further information available on request.

Mainos käännettiin automaattisesti ja käännösvirheet ovat mahdollisia.