Matala lavetti perävaunu

FLIEGL DTL 300 Agrar Hydraul. 3-Achs Tieflad

Total weight: 24,000kg / 30,000kg
Unladen weight: 5,600kg
Payload: 18,400 / 24,400kg
Overall length: 10,290mm
Loading length: Total 8,070mm; 5,900mm incl. rear bevel; 2,170mm gooseneck section
Width: 2,520mm
Loading height: 860mm
Additional information
plus pre-carriage / provision from stock location 26639 Wiesmoor: €1,280.00 / net

Steel welded construction
Turntable with heavy-duty ball bearing slewing ring
Foldable rear support
Wheel chocks with holder
Full-width rear spray flaps
1 plastic toolbox
Prepared for extensions up to 3,000mm (holes in outer frame with covers; not in rear bevel)
Low loader lashing rings
1 pair of lashing cut-outs recessed in front longitudinal beam at the gooseneck, each with 10 tons
7 pairs of lashing mushrooms recessed top and side in the outer frame, each with 10 tons:
- 1 x at the front on the gooseneck
- 5 x in the low-bed
Itedpfowt Nkrsx Abwer
- 1 x in the rear bevel
12 pairs of lashing holes in the outer frame, each with 5 tons (for securing straps):
- 5 x gooseneck, 6 x low-bed, 1 x rear bevel
Towing device for turntable trailer
Drawbar with tested 40mm towing eye
Drawbar height adjustable by spring
Axles & Suspension
Drum brake axles, manufacturer’s choice
"Axles/chassis laser-aligned": reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load equalization
(rocker equalization)
Wheels and Tires
235 / 75 R 17.5", manufacturer’s choice
Steel rims in twin arrangement, factory silver
Braking system
2-line compressed air brake system
Spring-actuated parking brake
2 fail-safe coupling heads at the front with connecting lines to the tractor unit; connections extended by approx. 60 cm
No ABS, but with mechanical ALB, thus max. 60 km/h approval
Electrics
12 Volt, multi-chamber lights, no lateral yellow LED lighting, side reflectors
2 white position lights at front
2 white/red outline marker lights at rear
1 x 7-pin 12 Volt socket at front with connection cable, extended by approx. 60cm
1 LED beacon with bracket, switchable via parking light (removable light)
2 pairs of warning boards, double LED lit and extendable to 3,000mm
Floor
Gooseneck front area with steel / anti-slip plate covering
Storage box recessed into the transition incline towards the gooseneck
afterwards with 70mm softwood floor, steel / anti-slip plate in wheel arch area
Rear bevel with 70mm softwood floor
Low-bed loading area incl. rear bevel: 5,900mm
Ramps
Steel ramps, 2,800mm long, 750mm wide, laterally adjustable
Wood-covered (ramp ends with steel/anti-slip plate)
Hydraulically powered by tractor PTO with throttle, operated at the side (left front)
Hydraulic connection with SVK plug NW 10/3, including connecting hose
Operating instructions
For 10,000 kg axle load, an exemption permit is required; only indivisible loads permitted!
The specified total weight is technically possible; depending on the load, the total weight may not be reached within allowed axle/support/kingpin loads. (Poor driving and tracking performance possible due to incorrect load distribution)
Registration country / Plates
Registration country: Germany
With Dekra inspection and report, for max. 60 km/h approval, towing vehicle LoF; (maximum 40 km/h permitted for Switzerland)
Prepared for two-line license plate holder
Without contour marking / reflective tape according to ECE R 048
Paint
Frame: RAL 7021 black grey
"10 years anti-perforation warranty"
Drawbar: galvanized or black,
manufacturer’s choice
Ramps fire-re...

Mainos käännettiin automaattisesti ja käännösvirheet ovat mahdollisia.