Nosturiauto

Volvo FH 540 8x2 Crane truck w/ 165 t/m HIDROKON crane w

Please provide reference number upon request: 20511

Specifications:


2021 model
7350 km (will go a little)
721 Engine hours
241 Crane hours
Euro 6 engine
8x2
551 HP
Suspension on 1st and 2nd axle: Steel
Suspension on 3rd and 4th axle: air
2 x 110 liter variable pumps
2 x manual extensions for main boom and 2 x for jib
Scanreco optical remote control (Top model)
Weight cell main boom
Additional function for main boom and jib
Auto leveling (The car puts itself in a level position ready for lifting.)
Virtual space (Possibility to limit all axes with a few keystrokes, no need to open a workshop for this. Brilliant when working under high voltage etc.)
SKF central lubrication ring and up to the first link
Extra function all the way up the jib
Single winch hook (Jib / main boom)
2 shear winch hooks (Jib / main boom)
4-point winch hook (Main boom)
Hook for jib
Hook for main boom (Large hook)
N d lower the generator (24 volts)
Cable stop sensor and sleeve
4 ton winch
Diagnostic cable for online help (Remote help)
Danfoss valve center
2 x 2 ton counterweight (M is only used for cranes above the cabin, otherwise the counterweights are not needed, and these can be removed as needed)
Front support leg

 

Structure:


4 x work lights strategically placed inside each outrigger cabinet.
50" LED bar work light at the rear of the cab
Powerful LED lights in the crane.
Bcodewlm Dtepfx Ahuou
VBG mount, with air servo control unit mounted in rear cabinet left side.
Roof rack
2 high beam LED bar on roof forward (daylight!!).
Orange work warning LED beam on the roof.
EasyUp foldable ladder with side railing.
Boxes for chains, screws, etc. Mounted on the rear support legs so that they are extended together with the support legs and are also packed away while driving.
Charger for control in cabin
Plastic inner fenders axle 3 and 4.
3 edge pull-out cabinet between axles 3 and 4
On the left side between axles 2 and 3, a large cupboard with a 500 W fan heater is installed for hanging clothes to dry, etc.
Flat / bottom rear closed with alloxed aluminum door panels that are cut to fit the car perfectly, with rounded edges for a very professional look.
CNC manufactured plates up the back of the cabin.
Fully painted sides, cabin and stern.
Crane rest cradle for operation without jib.
5 pcs support leg plates. 4 pcs 80x80x6 cm. placed in dedicated cribs at the back of the "plan"
Right side large cabinet 1.2 x 1 meter
Powerful LED reversing/rear work lights.
The rear of the car was rebuilt with CNC manufactured plates, and beautiful LED taillights have been installed in several stages.
Hatches strategically placed for access to relevant facilities under the building.
Precisely cut out panels in side coverage for access to screen, manual controls, emergency...