Työalustallinen perävaunu

MÜLLER-MITTELTAL T4 40,0 , Agrar, hydr. Rampen,3 m. Paket

* T 4:
* EBS
* Emergency release system for spring accumulators
* Drum brakes
* 4 x 11 to. Gigant axles
* Parabolic springs
* Mech. axle compensation front and rear
* Tire pressure monitoring with display option in the truck via EBS signal - without truck-side installation
* Warning sign packages front & rear
* Reflective contour striping on the sides and rear
* EBS multi-voltage system for 12 & 24 V electrical systems
* LED rotating beacon (removable) at the rear
* 24 V - 15-pin and additionally 12 V - 7+4 pin power cable
* Extended connection cables for agricultural and forestry tractors
* LED lighting
* Straight drawbar with 40 mm drawbar eye and stepless height adjustment
* Toolbox made of powder-coated sheet steel and spare wheel holder in body design, located on the right side
* Front, closed, plastic single mudguards
* Rear, straight steel mud flaps each with splash protection (spray mist suppression)
* Side underrun protection
* Extended offset crank extended by 500 mm to the front
* Extension of the turntable platform by 520 mm with 45° corners and 3 recessed storage compartments incl. lid and lockable
* Chassis made of high-strength fine-grain steel
* Floor over the turntable platform made of 50 mm and in the low-bed platform made of 60 mm needle wood
* Outer planks of the ramps made of 50 mm bamboo wood
* 4 pocket sleeves on each side (but no stanchions present) with simultaneous 2 to. lashing capability
* Lasi package consisting of: 2 lashing eyes 6.4 to. at the front left and right on the main frame of the turntable platform, 1 pair of 13.4 to. lashing rings on the outer frame on the front and rear sides, and 4 pairs of 10 to. lashing rings on each side, pivotable and lowerable, loadable in all directions and embedded in the outer frame, 2 pairs of lashing rings 6.4 to. on each side in the excavator arm rest, 8 pairs of galvanized folding outriggers for 3 m total width (but not in the rear slope)
* Extension planks stored on the left side in a storage compartment
* Excavator arm rest above the rear axle to the end of the approach ramp approx. 2,300 x 740 x 190 mm
* Mech. support legs at the rear
* Hydr. hot-dip galvanized ramps approx. 3,000 x 720 mm
* Hydr. lateral ramp displacement on sliding tube from the ramp shaft
* Loading area above the slewing ring: approx. 2,990 x 2,520 mm
* Rear loading area: approx. 6,280 x 2,520 mm
* Loading height loaded approx. 860 mm (incl. 860 mm approach ramp)
Nlodpfx Alorczm Ds Tec
* Chassis, turntable, ramps, mech. folding supports at the rear hot-dip galvanized
* Axles, springs, air tanks and slewing ring painted in a black tone
* New vehicle with manufacturer's warranty
* Errors and prior sale reserved
* Immediately available from Egestorf

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.